Building a proper control room – final tweaks using EQ, primary diffusion & installation of a sub-woofer

Hi there and welcome back! We are slowly nearing the end of this series. Today we will have a look at what EQ correction can do as a final tool. Furthermore, after a little bit of research on the web, I decided to tune the bass region a little more by installing and tuning a … Continue reading Building a proper control room – final tweaks using EQ, primary diffusion & installation of a sub-woofer

Building a proper control room -construction of a cloud absorber

Hi there! We are moving forward with our control room series. Today we install a cloud absorber, i.e., a broadband absorber on the ceiling between speakers and listening sweet spot to tackle early reflections on the ceiling. Of course, we are going to analyze what difference that makes to the measurements. Since the cloud absorber … Continue reading Building a proper control room -construction of a cloud absorber

Building a proper control room – recovery of mid and high frequency response by the use of wooden boards

Hi there! It's time for the fifth article in the control room series. This time we're gonna talk about how to recover mid and high frequencies without affecting the bass frequency absorption too much. I have done this by using wooden boards that are mounted onto the bass absorbers with certain slits in between them. … Continue reading Building a proper control room – recovery of mid and high frequency response by the use of wooden boards

Building a proper control room – mounting fabric and difference measurements

Hi again! Welcome back to the fourth article in this series. Today it's time to see what difference it makes if two layers of cotton fabric are mounted above the construction that we already measured last time. Since that task is quiet simple, today's article will be relatively short. The primary reason we want to … Continue reading Building a proper control room – mounting fabric and difference measurements

Building a proper control room – construction of bass traps

Hi and welcome back to the third article in this series. After we discussed the prerequisites, came up with an acoustic design concept and did the first measurement of the naked room, it's now time to actually start construction works. Along the line of our acoustic design concept we will start with building a wooden … Continue reading Building a proper control room – construction of bass traps